Water treatment plant

Water treatment plant

Water Treatment Plant

Water Recycling system for stone and glass fabrication shops
The system occupies only 2x2 meters, it is capable of clarifying over 400lt per minute or 100 gallons per minute of sludge.
This water treatment plant is equipped with a smart control unit that manages it in all its functions.
The entire system is pressurized solely by the wastewater suction pump, which is operated by an inverter and dynamically controlled maintaining a constant pressure throughout the system.
The flocculant is dynamically dosed in relation to the amount of water being used.
This system is easy to install and maintain (service)
The operating cost of this water clarification plant is low thanks to dynamic pressure and flocculant controls.
Calculator
Water treatment

Water Treatment Plant inner

Water treatment

The flocculant is dynamically dosed in relation to the amount of water being used.

Water treatment plant

Clarified water to factory

Water treatment plant
Water treatment plant
Water treatment plant

Water Treatment Plant Filter net

Water treatment plant

Collect the sludge

Water treatment CNC software

Water Treatment Plant CNC

Water treatment plant

Large particles filtering mesh

Water treatment plant size

Water Treatment Plant size

Calculator

Basic information
1. Approximate amount of water needed by the company per minute
*This value is acquired by observing the monitor of the system while the machine is running and the plant is in operation. It is an average value, more or less 100 liters, which is not a problem. It's important to know that the machine can clarify a maximum of 400 liters per minute.
2. Capacity of the coagulant pump
*The pump for injecting coagulant or flocculant has a maximum capacity of 50 ml per minute.
Test mixture for coagulant or floculant
3. Amount of water
*To make the test mixture, how much ml water did you use?
4. Amount of chemical
*For the test mixture, how many grams of chemical (coagulant or flocculant) did you add to the water?
Test on dirty water:
5. Amount of dirty water
*After preparing the mixture, you tested it in a certain amount of dirty water to see how much of this mixture is needed for coagulation or flocculation. You used a graduated syringe to add the chemical to the dirty water, and slowly added one milliliter or less until you observed that it was working effectively. The coagulant should be added first; its task is to attract the dirt particles, but even when united, the particles remain light. That's why you add the flocculant, which makes them heavier and causes them to settle. There are different types of flocculants, some that cause settling and some that bring particles to the surface, so testing is required to determine the optimal amount needed. For your purpose, you need one that causes settling of the dirt.
6. Amount of chemical in dirty water
*How many milliliters of chemical did you add to the dirty water before seeing the reaction?
Result
Amount of mixture